Generally, most of Jinan rolling shutter manufacturers will provide installation services for users, but some customers want to install their own rolling shutter products. So, what should I pay attention to when installing? What is the specific installation process? Here is the specific content of the installation.

　　基本的安装过程:

　　Basic installation process:

　　1. 控制箱预留PVC管从底部到地面，穿过墙壁到外面，并与地面在一定距离内，供室外电路进入房间、接线、调试控制箱开关。

　　1. PVC pipe is reserved for the control box from the bottom to the ground, through the wall to the outside, and within a certain distance from the ground, for the outdoor circuit to enter the room, connect and debug the switch of the control box.

　　2. 调整开口的长度。如果条件允许，开口的全长可以进一步延长到一定长度。这样检查孔就可以变成一个小门，方便以后的检查。

　　2. Adjust the length of the opening. If conditions permit, the full length of the opening can be further extended to a certain length. In this way, the inspection hole can be turned into a small door for later inspection.

　　3.当电源被引导到控制箱的下端时，需要有漏电保护装置，该装置被PVC覆盖。确定通信室内控制箱的位置，即操作电动卷帘门开关的设备的位置。

　　3. When the power supply is led to the lower end of the control box, leakage protection device is required, which is covered by PVC. Determine the position of the control box in the communication room, that is, the position of the equipment operating the electric rolling shutter door switch.

　　4. 安装完成后，铺设轨道时，应与轨道上的地面配合。铺设轨道时，注意路面，防止轨道弯曲。

　　4. After installation, when laying the track, it shall cooperate with the ground on the track. When laying the track, pay attention to the road surface to prevent the track from bending.

　　5. 另外，安装后要进行质量测试。抗风卷帘门是由电机控制升降帘子，需要检查门升降时是否有缓冲过程。这是衡量门质量的重要指标。

　　5. In addition, quality test shall be carried out after installation. The anti wind rolling shutter door is controlled by the motor to lift the curtain. It is necessary to check whether there is a buffer process when the door is lifted. This is an important indicator of door quality.

　　安装的注意事项:

　　Precautions for installation:

　　1、卷帘门安装位置上端应设置可靠的防火装置。在制作包装箱或天花板时，应在门轮的下端安装可拆卸盖板。电动卷帘门机的下端侧应预留一个可拆卸的人孔，以方便检修。

　　1. Reliable fire protection device shall be set at the upper end of the installation position of the rolling shutter door. When making the packing box or ceiling, the removable cover plate shall be installed at the lower end of the door wheel. A detachable manhole shall be reserved at the lower side of the electric rolling shutter door machine to facilitate maintenance.

　　2、操作卷帘门时，操作者应站在查看门运行状态的位置，否则容易发生事故。

　　2. When operating the roller shutter door, the operator shall stand at the position to check the operation status of the door, otherwise accidents may occur easily.

　　3、不要接触酸或碱溶液，以防止窗帘表面腐蚀。

　　3. Do not touch acid or alkali solution to prevent corrosion of curtain surface.

　　卷帘门在运行中，应定期检查滑动、传动等部件，并根据需要及时加油，以保证门的正常使用。

　　During the operation of the rolling shutter door, the sliding, transmission and other components shall be checked regularly, and oil shall be added timely as required to ensure the normal use of the door.

　　防风的百叶窗

　　Windproof shutter

　　5、防风百叶窗在开关停止过程中,应该停止的功能与地位,不应该停止和继续滑动现象,如滑动距离太大,应立即在快门控制电器和快门机器上刹车仔细检查和修复,操作正常。

　　5. In the process of switch stop, the function and position of the windproof shutter should be stopped. It should not stop and continue to slide. If the sliding distance is too large, the shutter control appliance and shutter machine should be braked immediately to check and repair carefully. The operation is normal.

　　6、做好门的保养和保养，特别是对于卷帘门容易生锈的部位需要定期进行防腐、喷漆和保养处理，不能使用重物、硬物冲击门面。

　　6. Do a good job in the maintenance of the door, especially for the parts easy to rust on the roller shutter door, which need regular anti-corrosion, painting and maintenance treatment, and do not use heavy objects or hard objects to impact the door surface.

　　7、卷帘门操作时若有大震动或异常声音应停止检查，排除障碍物使窗帘正常启闭的杂物。

　　7. In case of large vibration or abnormal sound during the operation of rolling shutter door, the inspection shall be stopped to remove the sundries that make the curtain open and close normally due to obstacles.

　　门安装好后，测试一下，看看是否有什么地方没有安装好。另外，用户平时一定要做好防风卷帘门的维护和保养工作，以免出现门机出现故障问题，影响正常工作。如果用户不知道如何操作，可参考以上内容进行清洗处理，以延长门的使用寿命。

　　After the door is installed, test to see if there is any place not installed. In addition, the user must do a good job in the maintenance of the windproof rolling shutter door at ordinary times, so as to avoid the failure of the door machine and affect the normal work. If you don't know how to operate, you can refer to the above content for cleaning treatment to extend the service life of the door.

　　以上是济南卷帘门厂家小编为大家介绍的相关内容，想要了解更多内容，欢迎访问网站：http://www.jiahuawenti.cn

the above is the relevant content introduced by jinan roller shutter manufacturer. if you want to know more, please visit the website: http://www.jiahuawenti.cn