1、 Electric induction glass door daily cleaning manual:

1 、清理门扇运行路面，确保电动感应玻璃门的运作运动轨迹正下方沒有废弃物及尘土，特别是全自动平（移）滑门的地滑轨要用吸尘机清理灰尘，卡死的脏东西要用医用镊子等专用工具清理（注意：避免划伤轨道）

1. Clean the road surface of the door leaf to ensure that there is no waste or dust directly below the operation trajectory of the electric induction glass door. Especially, the ground slide of the fully automatic sliding door should be cleaned with a vacuum cleaner, and any stuck dirt should be cleaned with specialized tools such as medical tweezers (note: avoid scratching the track)

2 、保洁服务电动感应玻璃门时，需要先按住急停按钮开关，选用软抹布和中性洗涤剂。

2. When using electric induction glass doors for cleaning services, it is necessary to first press and hold the emergency stop button switch, select a soft cloth and neutral detergent.

3、 清理电动感应玻璃门的照明灯具时，请在照明灯具灭掉15分鐘后清理，以防灯夹层玻璃因为受寒粉碎。

3. When cleaning the lighting fixtures of the electric induction glass door, please clean them 15 minutes after the lighting fixtures are turned off to prevent the laminated glass of the lights from being crushed due to cold.

4、 在清理电动感应玻璃门发动机部件自动开关、感应元器件时，应留意电器性，严禁运作中感应起电开展保洁服务工作。

4. When cleaning the automatic switches and sensing components of the electric induction glass door engine components, attention should be paid to the safety of the electrical appliances. It is strictly prohibited to use induction power during operation to carry out cleaning services.

5 、在清理电动感应玻璃门的感应识别装置及性光线传感器时、电子监控等装置时，应当心轻擦，以防刮及碰撞后更改电动感应玻璃门的控制器的感应视角和区域。

5. When cleaning the induction recognition device and safety light sensor of the electric induction glass door, electronic monitoring and other safety devices, care should be taken to wipe them gently to prevent scratching and changing the sensing angle and area of the controller of the electric induction glass door after collision.

6 、清理不锈钢板等包边条门边框时，尽可能选用专用型清洁剂，针对氟碳漆、空气氧化的表层。切勿选用强酸强碱腐蚀、特别是在是苯和甲苯等有机溶剂。

6. When cleaning stainless steel plates and other door frames with wrapped edges, special cleaning agents should be used as much as possible, targeting the surface layer of fluorocarbon paint and air oxidation. Do not use strong acids or alkalis for corrosion, especially in organic solvents such as benzene and toluene.

7、 禁止猛击敲击、自来水侵蚀电动感应玻璃门的门页，立在电动感应玻璃门的门上边爬行现浇板或雨罩。尽快密封门体上边的防潮防水对策，以防电器透水性返潮毁坏。

7. It is prohibited to forcefully strike or tap water to corrode the door leaf of the electric induction glass door. Standing on the door of the electric induction glass door and crawling on the cast-in-place slab or rain cover. Seal the moisture-proof and waterproof measures on the top of the door body as soon as possible to prevent damage to the electrical permeability due to moisture regain.

8 、电动感应玻璃门暂停服务三个月左右，提议拨掉主电源线插头，关掉UPS电源总开关。但若配备应急模块，务必每三个月插上主开关电源对锂电池组电池充电一次。

8. The electric induction glass door has been out of service for about three months. It is proposed to unplug the main power cord and turn off the UPS main switch. But if equipped with an emergency module, be sure to plug in the main switch power supply every three months to charge the lithium battery pack battery.